Denon AVR-S670H Owner's Manual page 224

Contents Connections Playback Settings Tips Appendix
z1 During playback in Pure Direct mode, the surround parameters are the same as in Direct mode.
z2 This item can be selected when a Dolby TrueHD signal is played.
z3 This item can be selected when a Dolby Digital, Dolby Digital Plus, Dolby TrueHD or DTS signal is played.
z4 This can be set when the LFE signal is included in the input signal.
z5 This item cannot be set when "Dynamic EQ" is set to "On". (v p. 134)
z6 This item cannot be set when Audyssey ® Setup (Speaker Calibration) has not been performed.
z7 This item cannot be selected when the Dolby TrueHD or DTS-HD input signal sampling frequency exceeds 96 kHz.
z8 This item cannot be set when "MultEQ ® " in the menu is set to "Off". (v p. 133)
z9 This item can be set when the input signal is analog, PCM 48 kHz or 44.1 kHz.
z10 This setting is available when "Low Frequency Effects" - "Subwoofer Output" in the menu is set to "LFE + Main". (v p. 163)
z11 This item can be set when "Crossovers" - "Front" is set to other than "Full Range" or "Low Frequency Effects" - "Subwoofer Output" is set to "LFE + Main". (v p. 162,
163)
224
Front panel Display Rear panel Remote Index