ADP 7966
Program selector knob
Mains On / Off
Start button
Switches "on" when the dishwasher is operating.
Flashes when a fault occurs. Switches off at the end
of the programme.
Indicators
Add rinse aid
Add regeneration salt
Only add regeneration salt immediately before
starting a wash programme.
Wash cycle
Pre-Rinse
Washing
Programmes
Sensor Normal
Sensor Intensive
Pre-Rinse
Glasses
Quickwash
Eco-Normal
1)
Reference programme for energy label in compliance with EN
50242 regulations;
2)
Refer to "User instructions";
3)
Program data obtained in conformity with European standard EN
50242. Values may vary in relation to usage, e.g.: different
loads, water temperatures - above or below 15°C - as well as
water hardness and power supply voltage, etc.
Important information for Test Laboratories:
For detailed information on the EN comparison test and other tests, contact the following address: "nk_customer@email.whirlpool.com".
Whirlpool is a registered trademark of Whirlpool USA
Before using the dishwasher, read the user instructions!
Quick Reference Guide
Programme
Drying
end
Programme chart
Loading instructions
Automatic programme recommended for
40-55°C
routine washes, with no dried-on or burnt
5)
food (not for EN 50242).
Automatic programme recommended for
60-70°C
heavily soiled crockery with dried-on or
5)
burnt food, for example pans and saucepans.
cold
Crockery to be washed later.
40°C
Light soiling, for example glasses and cups.
Lightly soiled crockery with no dried-on
40°C
food.
1) 5)
50°C
Normally soiled crockery.
Options
"Half load - Multizone" button
Load the upper or lower rack only.
This function can be used with any programme.
When washing without the top rack, press the
"Half Load" button twice, or "Lower rack wash"
(relative LED lights up).
Time and failure display
Indicates in hours the time remaining until the start of
the wash cycle. Switches off when the programme has
started. Toward the end of the programme, during the
drying cycle, the display will indicate the time
remaining in minutes.
"F...." Identification of faults for service technician
"Delayed start" button
The wash cycle can be programmed to start after
1 - 24 hours. With each successive touch of the button,
the delayed start indicator increases by 1 hour, and
after 24 returns to 00. Then press the Start button. The
dishwasher will start at the set time.
Antibacterial rinse
This function adds an antibacterial rinse at the end of
the wash cycle, thereby guaranteeing a perfectly clean
and sanitized load. The lamp will light up when the
function is activated. If the temperature is not
maintained during the antibacterial cycle (e.g. if the
door is opened and remains open for a long time), the
lamp will start blinking to indicate that sanitation is
not guaranteed.
Detergent
A
X
X
-
X
X
X
4)
The bacteria removal efficiency has been tested by
the Institut Pasteur de Lille (France), based on the
NF EN 13697 standard of November 2001.
5)
These programmes can be used with the Antibacterial rinse
option.
(We reserve the right to make technical modifications)
GB
3)
4)
2)
3)
Consumption
B
Litres
kWh
Minutes
X
10.0-13.0 0.80-1.05
50-110
X
13.0-20.0 1.10-2.00
90-140
-
4.0
0.03
14
-
10.0
0.80
55
-
10.0
0.65
30
X
13.0
1.05
120
5019 396 91343
WH/I/K/GB