Table of Contents
Advertisement
Quick Links
Quick reference guide
(see at right for options description)
PROGRAM SELECTION
START/RESUME BUTTON
BUTTON
Push this button to start the selected program: the
Push "P" button (repeatedly)
indicator lights up and goes off at the end of the
until selected program number
program.
is shown on the display
When the door is opened during a washing cycle,
(P1...Px) - see "Table of
the cycle is temporarily paused: the Start indicator
programs" below.
blinks. To resume the cycle close the door and
push Start button again.
Table of programs
Programs
P1
Sensor
40°-70°C
P2
Pre-Wash
cold
P3
Fragile
40°C
P4
Rapid
45°C
P5
2)
50°C
Eco
P6
Fast Daily
60°C
P7
Steam
P8
3)
Hygiene
1)
Program data obtained in conformity with European standard EN 50242, obtained under normal conditions (without additional options) and may vary depending on
conditions. Differences of up to 20 minutes are possible with sensor programs as a result of the appliance's automatic calibration system.
2)
Reference program for energy label in compliance with EN 50242 regulations. - Note for Testing Institutes: for detailed information on the
EN/Standard loading comparison test and other tests, contact the following address: "nk_customer@whirlpool.com".
3)
The antibacterial action has been tested by the Institut Pasteur of Lille (France), based on the NF EN 13697 standard of November 2001.
Whirlpool is a registered trade mark of Whirlpool USA
CANCEL/OFF BUTTON
Push this button to switch off the control panel.
If pressed when a program is running it cancels the
program ongoing draining water for 1 minute
(0:01 is shown into the display).
If pressed when the dishwasher is switched off,
it drains any possible liquids from dishwasher
(1 minute process).
Deter-
gent
Available
Loading instructions
options
Recommended program for routine
Delay
washes, with dried-on food (e.g. EN
Power Clean
50242).
Delay
Crockery to be washed later.
Light soiling, for example glasses and
Delay
cups.
Lightly soiled crockery, with no dried-
Delay
on food.
Delay
Normally soiled crockery.
Power Clean
Energy-saving program.
Delay
Normally soiled crockery.
Program including steam action
Delay
dedicated for heavily soiled crockery,
Power Clean
pots and pans. Soaking or hand
pretreatment is no longer needed.
Normally or heavily soiled crockery, with
Delay
additional antibacterial wash. Program
Power Clean
interruption (e.g. due to door opening)
can compromise elimination of germs.
Consumption
Drying
Phase
Litres
kWh
1)
Minutes
X
7-14
1.00-1.60
70-155
Full
—
4.0
0.03
14
NO
X
10.0
0.85
100
Light
X
11.0
0.80
30
NO
X
11.0
1.03
150
Full
X
10.0
1.30
80
Full
X
14.0
1.70
180
Full
X
13.0
1.50
118
Full
BEFORE USING THE APPLIANCE FOR THE FIRST TIME CAREFULLY READ THIS
QUICK REFERENCE GUIDE AND THE ASSEMBLY INSTRUCTIONS!
THE CONTROL PANEL OF THIS DISHWASHER ACTIVATES PUSHING ANY
BUTTON EXCEPT CANCEL/OFF BUTTON.
FOR ENERGY SAVING THE CONTROL PANEL DEACTIVATES
AUTOMATICALLY AFTER 30 SECONDS IF NO CYCLE HAS STARTED.
Options and display description
SALT INDICATOR
When lit (at the end of the cycle),
the salt reservoir needs to be
refilled.
WASH TIME DISPLAY
Indicated the cycle duration and the remaining time (h:min). With "Delayed start" selected it indicates
the time remaining until program start (h.00) - below 1h (0:min).
If "Fx Ey" messages appears on the display, see page 6 - chapter "What to do if...".
DELAYED START BUTTON
POWER CLEAN
Push the button (repeatedly) to
Thanks to the additional
power jets this option
delay the start of the program –
provides a more intensive
delay indicator turns on.
and powerful wash in the
Adjustable from 1 to 24 hours.
lower rack, in the specific
With each press of the button,
area. This option is
the delay increases by one hour
recommended for washing
and after "h 24" returns to
pots and casseroles (see
page 4). Press this button to
"h 00". When this option is
activate Power Clean (the
selected the delay indicator
indicator lights up).
turns on. Then press the
START button. The dishwasher
will start after the set time.
Chart
RINSE AID INDICATOR
When lit (at the end of the cycle),
the rinse aid dispenser needs to
be refilled.
TABLET SETTING
This setting allows to optimize
the cycle performances
according the type of
detergent used. Push the
Tablet button for 3 seconds
(until the indicator lights up) if
you are using the combined
detergents in tablet (rinse aid,
salt and detergent in 1 dose). If
you are using powder
detergent or liquid detergent,
the Tablet indicator on the
control panel has to be off.
5019 396 03653
GB -1-
Advertisement
Table of Contents
