Philips SP9890 Manual page 26

Table of Contents

Advertisement

26
English
Cleaning the beard styler attachment
2 Rinse the attachment under a warm tap.
3 After cleaning, switch off the appliance.
4 Carefully shake off excess water and let the
attachment air-dry completely.
Tip: For optimal performance, lubricate the teeth of the
attachment with a drop of sewing machine oil regularly.
Clean the beard styler attachment after each use.
1 Pull the comb off the beard styler attachment.
Note: Grab the comb in the center to pull it off the
beard styler attachment. Do not pull at the sides of
the comb.
2 Rinse cut hairs off the cutting unit with lukewarm
water.
3 Rinse cut hairs off the comb.
4 Remove the cutting unit from the beard styler
attachment. By pushing the cutting unit off the beard
styler attachment, you can remove any hairs that have
accumulated inside the beard styler attachment. You
can also rinse the bottom of the cutting unit.
5 Rinse cut hairs out of the beard styler attachment.
6 Carefully shake off excess water and leave the comb,
cutting unit and beard styler attachment to air-dry
before you use them again.

Advertisement

Table of Contents
loading

Table of Contents