Electrolux UFW 47 K 8161 User Manual page 16

Table of Contents

Advertisement

16
www.electrolux.com
10.11 Opening the door
CAUTION!
If the temperature and level
of the water in the drum are
too high and the drum still
rotates, you cannot open the
door.
While a programme or the delay start
operates, the appliance door is locked
and the display shows the indicator
Open the appliance door when the
programme or the delay start
operates:
1. Press
2. Wait until the door lock indicator
goes off.
3. Open the door.
4. Close the door and press again
The programme or delay start continues
to operate.
10.12 At the end of the
programme
• The appliance stops automatically.
• The acoustic signal operates (if it is
activated).
• In the display
• The indicator of the
• The door lock indicator
• You can open the door.
• Remove the laundry from the
appliance. Make sure that the drum is
empty.
• Close the water tap.
• Press the button
to deactivate the appliance.
• Keep the door ajar, to prevent the
mildew and odours.
The washing programme is
completed, but there is water in the
drum:
• The drum turns regularly to prevent
the creases in the laundry.
• The door lock indicator
door stays locked.
to pause the appliance.
comes on.
goes off.
goes off.
for some seconds
is on. The
• You must drain the water to open the
door.
To drain the water:
1. Press
water and spins.
2. To make the appliance drain only, set
. If necessary, decrease the
spin speed.
3. When the programme is completed
and the door lock indicator
.
off, you can open the door.
4. Press the button
seconds to deactivate the appliance.
The appliance drains and
spins automatically after
approximately 18 hours
(except for Wool
programme).
.
10.13 AUTO Stand-by option
The AUTO Stand-by function
automatically deactivates the appliance
to decrease the energy consumption
when:
• You do not use the appliance for 5
minutes before you press
Press the button
appliance again.
• After 5 minutes from the end of the
washing programme
Press the button
appliance again.
The display shows the end of the last
set programme.
Turn the programme knob to set a
new cycle.
If you set a programme or an
option that ends with water
in the drum, the AUTO
Stand-by function doesn't
deactivate the appliance to
remind you to drain the
water.
. The appliance drains the
for some
.
to activate the
to activate the
goes

Advertisement

Table of Contents
loading

Table of Contents