Table of Contents
Advertisement
en Basic operation
13.8 Starting the programme
Requirement: A programme is set.
→ "Setting a programme", Page 30
Press
.
▶
The drum rotates and load detec-
a
tion takes place. This can take up
to 2 minutes, after which water
enters the drum.
The display shows the programme
a
duration or the programme end
time.
After the programme has ended,
a
the display shows: End.
13.9 Adding laundry
After the programme starts, you can
remove or add laundry depending on
the programme status.
Press
.
1.
The appliance pauses.
Note: If you want to add laundry,
follow the instructions on the dis-
play.
→ "Display", Page 22
Open the door.
2.
Add or remove laundry.
3.
Close the door.
4.
Press
.
5.
13.10 Cancelling the pro-
gramme
Press
.
1.
Open the door.
2.
The appliance door remains
locked for safety reasons if the
temperature and water levels are
high.
– If the temperature is high, start
the Skylning programme.
32
– If the water level is high, start
the Centrifugering programme
or select a suitable programme
for draining.
→ "Programmes", Page 25
Remove the laundry.
3.
→ "Unloading the laundry",
Page 32
13.11 Resuming the pro-
gramme when the pro-
gramme status is Rinse
Hold
Requirements
Rinse Stop is activated.
¡
The last rinse cycle of the set pro-
¡
gramme has ended and the laun-
dry is in the rinsing water.
Set the Centrifugering programme
1.
or a programme for draining the
water.
→ "Programmes", Page 25
Press
.
2.
13.12 Unloading the laundry
Open the door.
1.
Remove the laundry from the
2.
drum.
13.13 Switching off the appli-
ance
Turn the programme selector to
1.
Turn off the tap.
2.
.
Advertisement
Table of Contents
