The First Wash Cycle; Technical Data - Hotpoint RPD 9477 D Instructions For Use Manual

As the colours of the wires in the lead may not
GB
correspond with the coloured markings iden-
tifying the terminals in your plug, proceed as
follows:
Connect Green & Yellow wire to terminal
marked E or
Yellow.
Connect Brown wire to terminal marked L or
coloured Red.
Connect Blue wire to terminal marked N or
coloured Black.
If a 13 amp plug (BS 1363) is used it must be
fitted with a
13 amp fuse, either in the plug or adaptor or
at the distribution board.
If you are in any doubt regarding the electrical
supply to your machine, consult a qualified
electrician before use.
How to connect an alternative plug:
The wires in this mains lead are coloured in
accordance with the following code:
BLUE
BROWN
GREEN & YELLOW
GREEN &
YELLOW
BROWN
BLUE
Disposing of the appliance:
When disposing of the appliance please re-
move the plug by cutting the mains cable as
close as possible to the plug body and dispo-
se of it as described on the previous page.
! The washing machine should not be installed
in an outdoor environment, not even where
the area is sheltered, because it may be very
dangerous to leave it exposed to damp, rain
and thunderstorms.
! When the washing machine is installed, the
mains socket must be within easy reach.
! Do not use extensions or multiple sockets.
! The power supply cable must never be bent
or dangerously compressed.
4
or coloured Green or Green &
NEUTRAL (N)
LIVE (L)
EARTH (E)
13 ampere fuse
CROSS-BAR
CORD GRIP
! The power supply cable must only be repla-
ced by an authorised serviceman.
Warning! The company denies all liability if and
when these norms are not respected.

The first wash cycle

Once the appliance has been installed, and
before you use it for the first time, run a wash
cycle with detergent and no laundry, using
wash cycle number auto clean (see "Cleaning
the washing machine").

Technical data

RPD 9477 D
Model
width 59.5 cm
height 85 cm
Dimensions
depth 60,5 cm
Capacity from 1 to 9 kg
please refer to the technical
Electrical
data plate fixed to the ma-
connections
chine
maximum pressure
1 MPa (10 bar)
Water con-
minimum pressure
nections
0.05 MPa (0.5 bar)
drum capacity 62 litres
up to 1400 rotations per
Spin speed
minute
Test wash
Eco Cotton 60°C
cycles in
programme 11 and Eco
accordance function enabled.
Eco Cotton 40°C
with re-
gulations programme 11, Eco function
enabled and lower the tem-
1061/2010
perature down to 40°C.
1015/2010
This appliance conforms to
the following EC Directives:
- EMC - 2014/30/EU (Elec-
tromagnetic Compatibility)
- LVD - 2014/35/EU (Low
Voltage)
- 2012/19/EU (WEEE)
:
60°/40°
:
60°/40°