Toro Recycler 21060 Operator's Manual page 9

8
11
© 1998 by The Toro Company
9
avarage height of lawn
normal dense
9 cm
8 cm
7 cm
5,5 cm
4 cm
setting height-of-cut B - F
3.5 Attaching the grass-collecting device
1. Put the fabric of the collecting sack from behind onto the
frame (Fig. 8).
Slide the upper plastic profile underneath the handle to the
front and clip it there.
2. clip the other plastic profiles around the frame.
3. clip the plastic profile (Fig. 9)
3.6 Adjusting the cutting height
Adjust cutting height only when the motor
is turned off.
10
The cutting height is adjustable with a six-step central height
adjustment.
1. Hold the lawn mower by the handle above the ejection door.
2. Press the red pushbutton (Fig. 10).
3. Adjust the cutting height by means of the scale keeping the
push button pressed and moving the mower up and down
(Fig. 11).
4. Let the push button go. The mower will be locked in the
desired position.
3.7 Proper cutting height
The left rear wheel bears a scale (Smart Wheel) for reading the
appropriate cutting height (Fig. 12).
Left scale = normal grass
Right scale = dense grass
During the warm summer months, adjust cutting height according
8 cm
to the scale „normal".
For dense, thicker or damp grass e. g. in spring, use the scale
7 cm
„dense".
6 cm
Never use position "A" for recycling
5 cm
In easy and suitable conditions, position "B" is possibletouse,
recommended for recycling is "C", "D" or "E".
3,5 cm
1. First push the mower onto the lawn - the scale must be
parallel to the ground.
2. Now you can read the length of the uncut grass on the scale
and choose the recommended adjustment.
12