Toro Recycler 21060 Operator's Manual page 12

12
18
4.2 Recycling
For recycling the Recycler plug must be inside the ejection
channel.
1. Ensure that the motor and the cutter stand still.
2. Open the ejection door.
3. Push the Recycler plug into the ejection channel. The
Recycler plug must lock (Fig.18)
4. Close the ejection door.
To remove the Recycler plug, rum the motor off and
wait until the cutter stands still.
Open the ejection door and pull the Recycler plug out. Close the
ejection door.
• Ensure that the cutter is always sharp. Notches may be
removed by means of a file (mind the unbalance).
• After each mowing the grass rests must be removed from the
19
bottom side of the mower, from the deflectors and from the
Recycler plug (Fig. 19).
• With grass heights greater than or equal to 15 cm, the lawn
should be mowed in two steps.
• In hot summers, adjust the cutting height on C, D, E or F.
Do not cut off more than a third of the grass leaf.
When mowing in high grass, you should select a higher cutting
adjustment first. Then mow with the usual adjustment.
Lumpy grass and chockings inside the mowing channel effect a
throttling or stop of the motor. In such cases, you should mow at
least one step higher.
© 1998 by The Toro Company