Toro Recycler 21060 Operator's Manual page 10

13
16
10
14
3.8 Connecting the lawn mower
Important:
Use only approved outdoor extension cables with a
metallic section of at least 1.5 mm².
• Check the cable for defects.
Never use a damaged cable.
• Keep the cable off the cutter when mowing.
• Do not let the cable chafe on edges and pointed or sharp
objects.
Do not pinch the cable.
1. Fasten the connecting cable leading to the motor to the
handlebar by means of the holding straps.
2. Connect the cable to the plug-in socket on the handlebar
15
(Fig.13).
3. Secure the cable with the strain relief (Fig. 14 + 15).
It is imperative to use the strain relief.
Make sure that the cable section between the plug-in socket
and the strain relief is of sufficient length so that the strain
relief may slight over the whole width of the handlebar (Fig.16)
4. Connect the mains plug.
Note: Use an extension cable of the appropriate length. Extra-long
cables lead to a power loss and a reduction of the mowing
capacity.
If using a cable drum, unwind the cable completely, otherwise the
cable drum might heat up to an unacceptable extent.
Disconnect the mains plug when leaving the mower.
Do not take the mains plug of the socket by pulling on
the cable.
© 1998 by The Toro Company