Table of Contents
Advertisement
OPERATION
NOTE:
l
Make sure to refill the fuel tank in time. Do not let the engine run so all the fuel is used. This
might cause starting problems.
l
Prevent the screed of sinking into the concrete. After the engine has been switched on,
immediately move the Screed Easy backwards.
l
When using a low slump concrete, move the screed slowly across the surface of the
concrete. When using a high slump concrete, move the screed faster across the surface of
the concrete.
l
When the screed is used as a wet screed it is recommended to first compact the freshly
poured concrete with a poker vibrator while at the same time set the height of the floor by
means of a laser device.
2.5 Operation
The drive-unit of the screed is started by pulling the recoil-starter of the engine. The
vibrating beam of the screed compacts, levels and smooths freshly poured concrete in one
operation. The screed features a dual purpose beam and can be used for form-to-form
screeding or for free screeding.
By rotating the power-unit 180 degrees, the operator can choose between screeding, using
forms/rails, or free screeding.
2.6 To Stop
To stop the engine in an emergency, turn the engine switch to the OFF position (on the
equipment side). Under normal conditions, use the following procedure:
1. Position the throttle control lever fully to LOW (on the equipment side).
2. Turn the engine switch to the OFF position (on the equipment side).
8
Advertisement
Table of Contents
