Dometic Midi Heki FL Installation And Operating Manual page 9

Midi Heki FL
6.4 Lever version
See fig. 0
➤ Press the inner frame into the groove (1) on the mounting supports.
See fig. a
The inner frame can additionally be fastened with 2 screws on the short sides and/or
4 screws on the long sides (the necessary screws are not included in the scope of
delivery):
1. Disassemble the ventilation grilles.
2. Drill the fastening holes beforehand.
3. Screw the screws into the fastening holes.
4. Clip on the ventilation grilles.
They need to click in.
I
NOTE
If the protective film is exposed to sunlight for too long, it cannot be
taken off without leaving a residue.
1. Remove the protective film from both sides of the acrylic glass.
2. Check the functions of the window:
– Open the roof light (see chapter "Using the lever version" on page 12).
– Adjust the insect and the black roller blind.
3. If necessary, enter the new vehicle height and weight in the vehicle documents.
6.5 Electric version
See fig. 0
1. Plug the connector (1) of the switch cable into the socket (2) of the motor.
A
NOTICE! Damage hazard
Ensure that the polarity is correct:
• Red wire: Positive terminal
• Black wire: Negative terminal
2. Connect the 12 V power supply line from the vehicle to the motor's 12 V line (3).
3. Connect the of the ground cable from vehicle to the motor's ground cable (4).
EN
Installation
9