Installation - Dometic Midi Heki FL Installation And Operating Manual

Installation

➤ When choosing the installation location, observe the following:
– Adjoining components (roof rack or attachment and reinforcing parts), cables
and cabinets in the vehicle interior must not be damaged when sawing a
hole.
– Sufficient space needs to be available for installing the inner and outer frames.
– Only fit the roof light on flat and parallel interior and exterior roof areas with a
maximum inclination of 15° to the horizontal.
– You may use an existing roof hole provided the roof light fits into it.
Electric version only
➤ Ensure that a power supply line is available in the vehicle for the device's electri-
cal actuation.
➤ Ensure that the power supply line is fused with 10 A (slow-blow).
6 Installation
A
NOTICE! Damage hazard
If you do not have sufficient technical knowledge for installing the
components in vehicles, you should have a specialist install the roof
window in your vehicle.
6.1 Cutting out the hole
See fig. 2
6.2 Using reinforcing rails
Supplements fig. 3
1. Before installation, check whether the roof hole needs reinforcing.
2. Remove the foam according to the width of the reinforcing rails (not in scope of
delivery) (A).
3. Fit the reinforcing rails (B).
6
Midi Heki FL
EN