Instructions For Certification - Diaphragm Pumps Mpc - Ilmvac MP 601 E Operation Manual

for use in Zone 2 in accordance with
device category 3 per ATEX Directive 94/9/EC
1. Type test – Effects of the ATEX Directive
Thanks to its design this device meets the requirements imposed upon devices of device group II and
device category 3 in conformity with Directive 94/9/EC of the European Parliament and Council dated
23 March 1994 on the harmonisation of the legislation and administrative regulations of the member
states with regard to devices and protection systems for use in atmospheres capable of being ignited.
According to the regulations for category 3, these devices are intended to be connected to apparatus
in which in normal operation a mixture of gases or vapours capable of being ignited does not normally
occur or with a high probability does so only seldom and briefly.
The following instructions absolutely must be observed when using these devices.
• Because of the identical construction in principle of the devices of category 2 certified by IBExU
(notified body), these studies relating to the internal space are used for illustration purposes.
This certification relates to the following device types:
The certification is a type test per Directive 94/9/EC (ATEX95). It relates to all the devices of the
manufacturer "ILMVAC GmbH" with the designation "EX II 3G IIC T3X."
In the specific case these are devices with the following type designations:
• MPC ... - devices with a diaphragm diameter of 75, 95 and 97 mm.
201 E; 601 E; 1201 E; 2401 E; 602 E;
101 Z; 301 Z; 901 Z; 1801 Z; 302 Z;
301 Z ef; 601 T ef; 1201 T ef;
201 T; 601 T; 1201 T
The certification relates to all versions including those that vary from the basic types.
A precondition here is that the internal area in contact with the gas has not been changed.
Key:
• MPC
- Designation
• EX
- ATEX Directive 94/9/EC
• 03
- Device category 3
• 01
- Serial number of the internal certification
The "EX II 3G IIC T3X" certification is valid only for the internal space in contact with the medium and
the transport of gases and vapours. Installation and operation of the devices in an atmosphere capa-
ble of being ignited is not permitted.
ILMVAC_ATEX_03-01
Instructions for ATEX certification
Instructions for certification
- Diaphragm Pumps MPC -
« EX II 3G IIC T3X »
Internal atmospheres only
ILMVAC GmbH 1