4
8
• Lock the CPU by using a Torx T20 screwdriver to tighten screw.
• When installing the heatsink to CPU, use a Torx T20 screwdriver to tighten 6 captive nuts in
sequence as 1-6.
• The screw tightening torque: 12.5-15.0 kgf-cm.
• To ensure the system operates properly, make sure the heatsink is seated on the processor
firmly.
5
7
System Hardware Installation
- 27 -
6
2 2
1 1
3 3
5 5
4 4
6 6
9