Table of Contents
Advertisement
3-4
Removing and Installing the CPU and Heatsink
Read the following guidelines before you begin to install the CPU:
• Make sure that the motherboard supports the CPU.
• Always turn off the computer and unplug the power cord from the power outlet before installing
the CPU to prevent hardware damage.
• Unplug all cables from the power outlets.
• Disconnect all telecommunication cables from their ports.
• Place the system unit on a flat and stable surface.
• Open the system according to the instructions.
WARNING!
Failure to properly turn off the server before you start installing components may cause serious
damage. Do not attempt the procedures described in the following sections unless you are a
qualified service technician.
Follow these instructions to install the CPU:
1.
Loosen the three captive screws securing the CPU cover.
2.
Flip open the CPU cover.
3.
Remove the CPU carrier from the CPU frame using the handle on the CPU carrier.
4.
Using the handle on the CPU carrier insert the new CPU carrier with CPU installed into the CPU
frame.
NOTE: Ensure the CPU is installed in the CPU carrier in the correct orientation, with the triangle
on the CPU aligned to the top left corner of the CPU carrier.
5.
Flip the CPU frame with CPU installed into place in the CPU socket.
6.
Flip the CPU cover into place over the CPU socket.
7.
Tighten the CPU cover screw to secure the CPU cover in place.
8.
Place the thermal pad on the top of CPU.
9.
When installing the heatsink to CPU, use a Torx T20 screwdriver to tighten 4 captive nuts in
sequence as 1-6.
10.
Repeat steps 1-9 for the second CPU and the heatsink.
11.
To remove the CPUs, follow steps 1-7 in reverse order.
1
System Hardware Installation
- 26 -
External cap
3
2
Advertisement
Table of Contents
