Advertisement
TORCH WIZARD INSTALLATION & OPERATION MANUAL
1.3 SAFETY
The Non-Stop® Wire Dispensing System is designed to be safe to operate, provided the user reads, understands and adheres
to the safety precautions listed below. Failure to adhere to these precautions may result in personal injury and/or damage
to the equipment.
WARNING: WEAR EYE PROTECTION
When butt welding the wire ends together or deburring the wire after butt welding, always wear eye protection.
WARNING: WEAR PROTECTIVE GLOVES
When butt welding the wire ends together or deburring the wire after butt welding, always wear
protective gloves.
WARNING: ELECTRIC SHOCK HAZARD
Operators should always wear dry welding gloves and protective clothing when welding. Do not contact
electrically live parts. Keep welding guns and other welding equipment away from moisture and water.
Ensure ground connections are secure and compatible with the required electric current. When welding
under wet conditions or where perspiration is a factor, the use of automatic controls for reducing the no
load voltage is recommended to reduce the risk of electric shock. Accidental contact must be prevented
with open circuit voltage exceeding 80 volts AC, or 100 volts DC by using insulation or other means. When
welding gun is not in use, turn off power supply to prevent any accidental contact.
Welding equipment should be installed and maintained in accordance with National Electrical Code
(NFPA 70) and in compliance with local codes. Equipment should only be serviced by qualified or trained
personnel only. Do not disassemble torch or change welding consumables with the power supply on.
WARNING: ALWAYS SECURE WIRE DRUMS
Ensure all wire drums are firmly secured to the Non-Stop Wire System with the provided wratchet straps
to avoid roll away hazards.
2
Advertisement
