Table of Contents
Advertisement
WATER PRESSURE
Connection to water supply
Installation
Remove all protective packaging for transit before using
for the first time. Keep in case needed for future transit:
Transporting a non-secured appliance may damage in-
ternal components and cause leakages and malfunctions.
The appliance can also be damaged through physical
contact.
Unpacking
1
3
Untying
a
1b
2a
Minimum
Maximum
2
4
1a
1b
3
2
2b
0,05 MPa (0,5 bar)
0,8 MPa (8 bar)
Type 20/27
3
To install your washing machine at the same level as sur-
rounding furniture, proceed as shown on picture 4.
Water supply
Install the supplied water inlet hose at the rear of your
washing machine by proceeding as follows. Do not reuse
an old hose. The water inlet hose can not be extended. If
it is too short, please contact the after-sales service.
1
Open the water inlet tap. Check there are no leaks.
Drainage
Fit the U-piece on the drain-
age hose. Place everything
in a drainage point (or in a
sink) at a height of between
70 and 100 cm. Ensure it is
positioned securely. Air
must be able to enter the end
of the hose, to avoid any risk
of siphoning.
The drain hose must never be stretched. If it is too short,
contact an engineer.
Electrical connection
This washing machine must only be connected in single-
phased 230 V. Check the fuse size: 13 A for 230 V. The
appliance must not be connected with an extension lead
4
2
9
Advertisement
Table of Contents
