DeLonghi ENV300.B Manual page 40

The brewed quantity is not
enough.
Lever cannot be closed complete-
ly.
Quality of the milk froth is
down-graded
Milk carafe cannot be dismantled. • Press the button on the side of the milk carafe to remove the
Milk carafe is inserted but the milk
buttons are not enabled.
When Hot foam
chiato
buttons are blinking alternatively.
When Hot foam
chiato
buttons are blinking together.
40
• Check that the water tank is filled.
• Check if milk carafe is filled.
• See section "Setting the coffee volume".
• Empty capsule container. Make sure that no capsule is blocked
• Use semi-skimmed cow milk at refrigerator temperature
• Milk action knob is on remove to clean
• Rinse after each milk preparation and ensure the air inlet of
• Descale the machine (refer to section «Descaling»).
• Do not use either frozen milk or hot milk in the carafe.
• Ensure that all the components of the milk carafe are well as-
• Refer to section «Assembling / Disassembling of Milk carafe".
• The milk action knob is on rinse
• Make sure it is properly inserted.
• Machine overheat, wait until machine cools down.
, Latte mac-
and Cappuccino
• Water tank is empty.
, Latte mac-
• Fill the tank.
and Cappuccino
inside the capsule container.
(about 4° C).
milk position.
the milk action knob is clean. See section («Cleaning the milk
carafe»).
sembled. Refer to the section «Assembling the milk carafe».
milk carafe lid.
position. Wait for the coffee side to complete the heat up
position. Turn it to
position. Turn it to milk