Table of Contents
Advertisement
The machine doesn't start and the
lights blinks irregularly.
Lights blink while machine is run-
ning.
Lights blink and machine is not
running.
Lights blink irregularly.
Machine is not running.
Descaling alert blinks or is fixed
orange.
Rinse alert blinks orange.
I cannot enter the Menu Mode
(Reset to factory settings/ Empty-
ing the system before a period of
non-use/Water hardness setting).
Turn off the machine.
• Fill the water tank and push button to start.
• Check that handle is properly locked.
• If coffee or milk is flowing normally, this indicates the machine
is working properly.
• If only water is flowing, the machine is executing a user re-
quest for either cleaning, descaling or emptying the system.
Refer to the corresponding section in this user manual.
• It will take some time before the coffee flow comes out (due to
code reading and pre-wetting the coffee).
• Check that a fresh capsule is inserted in correct position, that
the handle is properly locked and push the button to start.
• Fill the water tank and push button to start.
• Turn the machine to "OFF mode" by pushing the coffee button
for 3 seconds and then push it again to turn the machine ON.
Now wait approximately 20 minutes to allow the machine to
cool down after extensive use.
• During regular Coffee/Espresso preparation: 1) Unlock the
handle and open the machine head to check that a fresh
undamaged capsule is inserted in the correct position.
2) Check that the handle is in "LOCKED" position. 3) Check
that the water tank is filled.
• During Descaling, Emptying and Cleaning: 1) Check that cap-
sule is ejected. 2) Check that the handle is in "LOCKED" po-
sition.
• During Programming Volume: 1) Check if a capsule has been
well inserted. 2) Please refer to the corresponding chapter.
• If problem persists:
• 1. Unlock the handle and open machine head.
• 2. Replace capsule (if needed).
• 3. Disconnect powercord from the outlet and plug the ma-
chine back into outlet after 10 seconds.
• 4. Close the head and press the button to turn ON and press
again to start brewing. If problem persists, call Nespresso.
• Machine triggers descaling alert according to your beverage
consumption. Descale the machine. Refer to section "Descal-
ing" according to your beverage consumption.
• A rinsing cycle of the milk carafe is required, refer to section
"Milk Preparation & Daily rinsing".
• Be sure to remove the milk carafe from the connector door.
• Be sure that the descaling pipe is not connected to the con-
nector door.
• Press and hold hot foam button
alerts blink.
• Hold the coffee buton
Saving " section.
until descale and rinse
for three seconds. See " Energy
39
Advertisement
Table of Contents
