Related Manuals for Holman 40237
Summary of Contents for Holman 40237
- Page 1 Instruction Guide 40237 Holman Rancho Cordova, CA 95742 800-343-7486 InstallationSupport@Holman.com 20221103R2 DATE: ________________...
- Page 2 Step 2A – Install to Van Rack ......................4 Step 2B – Install to Crossbar Rack ..................... 4 Before You Begin Read ALL instructions prior to installing any Holman product. Always CLOSE AND LOCK conduit carrier door before moving vehicle or transporting loads.
- Page 3 Instructions – 40237 Parts List Hardware For Technical Support Call: 800-343-7486, Monday-Friday, 7AM - 4 PM (PST) Page 2...
- Page 4 Instructions – 40237 Hardware (Continued) Step 1 – Assemble Conduit Carrier Tubes Set the forward half of the conduit carrier close to the rear half of the conduit carrier. Insert the foam seal between the front half and rear halves of the conduit carrier. Be sure to align the holes in foam seal with holes in front and back conduit carrier.
- Page 5 Step 2B – Install to Crossbar Rack The following instructions are for mounting to a crossbar rack, truck rack, or other manufacturers rack. If mounting to a Holman Clamp and Lock or Drop Down van rack, use Step 2A. NOTE: Front mounting bracket is a different size than rear mounting bracket. Be sure you have the correct mounting bracket before bolting to rack.
- Page 6 Instructions – 40237 Set the mounting brackets over the conduit carrier, centered over the rear edge of the crossbar. Insert a 3/8” x 3” carriage bolt through each hook. 3/8” x 3” Carriage Bolts Firmly hold hook against rear edge of crossbar.
Need help?
Do you have a question about the 40237 and is the answer not in the manual?
Questions and answers