Mounting Front Pivoting Casters; Mounting Rear Fixed Casters - Craftsman SP5373 Owner's Manual

assembmy
MOUNTING FRONT PRVOTING CASTERS
1, Locate the following items from the loose parts bag:
Description Qty.
A Pivoting Casters ................................... 2
B Hex Nuts* (3/8 - 16) .............................. 2
C Flat Washers* (3/8 x 3/4) ...................... 4
D Acorn Nuts*, ......................................... 2
E Base Plate ............................................ 1
2. Screw a hex nut completely on the Caster bolt.
3. Position flat washeron top of previously installed hex
nut and slip the Caster bolt through the hole on front
of Base Plate. Position secondflat washeron the bolt.
A
E
0*
* }terns are shown actual size
ACORN NUT_,
FLAT WASHER
4. Screw the Acorn Nut on the bolt securely with an
adjustable wrench.
5. Tighten the hex nut securely against the base plate.
6, Repeat steps 2 - 5 on opposite side.
i
MOUNTING REAR FIXED CASTERS
1. Locate the following items from the loose parts bag
Descrlptlon Qty.
A Fixed Casters ....................................... 2
B Flat Washers* (1/4 x 1/2). ..................... 4
C Lockwashers* (1/4) .............................. 4
D Hex Head Screws* (M6 x 1 - 12) .......... 4
2. Position Fixed Casterunder rear of Base Plate so that
holes on Caster bracket and Base Plate line up.
3. Install hex screw, lock washer and flat washer as
shown, Tighten securely using an adjustable wrench
4. Repeat steps 2 and 3 on opposite side.
i •
MOUNTnNG iNLET GUARD
A B'_
* Items are shown actual size
BASE PLATE
(REAR)
C_
CASTER
_HEX SCREW
FLAT WASHER
F.,_ED CASTER
1. Locate the following items from the loose parts bag:
Description Qty
A Flat Washers* (5/16 x 11/16 xl/16) ..... 4
B Hex Screws* (M8 x 1.25 -12) ............... 4
C Lockwashers ° (5/16) ............................. 4
A c
2. Locate the Filtration Housing and Inlet Guard. * Itemsare
shown actual
size
'H,.,HL L • .I, , I HI, I ,IHUIL._
*V