Chapter 3. Usage - Kernau KVC 101 Instruction Manual

• Attaching flexible hose:
Insert the hose end into the inlet port. Push until the end falls into place with an audible click (pic.1).
• Removing the hose:
Press buttons on the hose end, unlatch and remove the hose from the inlet port (Pic.2)
• Connect the telescopic tube with the hose (Pic.3) and the proper attachment (Pic.4, 5, 6), slide open
the telescopic tube to a suitable length.
• Grab the plug and pull the power cord while holding the appliance body, plug into a power outlet.
• Before you start vacuuming, extend power cord cable to sufficient length and insert the plug into the
wall socket. The yellow mark on the power cord indicates it is extended almost all the way. When you
see the red mark do not pull the power cord any further.
• Switch on the appliance with the on / off button (Pic.7).
• After finishing using the appliance, press the on/off button to turn off the vacuum cleaner (Pic. 7).
• Unplug the cord from the wall outlet.
• Retract the power cord by pressing cord re-tractor button (Pic.8). For this operation hold the cord
to prevent it from tangling or bumping the plug on the vacuum cleaner housing.
• Disconnect the suction cleaning head from the tube and disconnect the telescopic tube from the hose.
• Close the telescopic tube.
The vacuum cleaner may be stored in a vertical or horizontal position. The hose can remain attached to the
vacuum cleaner, but please be careful not to bend it too much during storage.
Pic. 1
Pic. 5

CHAPTER 3. USAGE

Pic. 2
Pic. 6
Pic. 3
Pic. 7
EN 18
Pic. 4
Pic. 8