Charging Times - Parkside PAAS 20-Li A1 Original Instructions Manual

GB CY
Noise and vibration values have been
determined according to the standards and
regulations cited in the original EC Decla-
ration of Conformity.
The specifi ed total vibration value and the
stated noise emission value have been
measured according to a standardised test
method and can be used to compare one
power tool with another.
The specifi ed total vibration value and the
stated specifi ed noise emission value can
also be used for a provisional assessment
of the load.
Warning: The vibration and noise
emissions may deviate from the
specifi ed values during actual use of the
power tool, depending on how the power
tool is being used and, in particular, what
kind of material is being worked with.
Safety measures for protection of the oper-
ator must be determined.
Charging time (min.)
PLG 20 A1
PLG 20 A4
PLG 20 C1
PLG 20 A2
PLG 20 A3
PLG 20 C3
PDSLG 20 A1
PDSLG 20 B1
Smart PLGS 2012 A1
6
PAP 20 A1
PAP 20 A2
PAP 20 B1
60 90
45 60
35 45
35 45
35 40
These are to be based on an estimate of
the actual vibration load under the real
operating conditions (for this, all parts of
the operating cycle are to be taken into
account, for example, times in which the
power tool is turned off, and those during
which it is turned on but running without a
load).

Charging times

The device is part of the X 20 V TEAM
series from Parkside and can be operated
using batteries of the X 20 V TEAM series
from Parkside. Batteries of the X 20 V
TEAM series from Parkside may only be
charged using chargers of the X 20 V
TEAM series from Parkside.
We recommend that you operate
this device with the following bat-
teries only: PAP 20 B1, PAP 20 B3,
Smart PAPS 204 A1, Smart PAPS 208 A1
We recommend charging these
batteries with the following chargers:
PLG 20 A3, PLG 20 A4, PLG 20 C1,
PLG 20 C3, PDSLG 20 A1, PDSLG 20 B1,
Smart PLGS 2012 A1
PAP 20 A3
PAP 20 B3
Smart PAPS 204 A1
120
80
60
60
50
Smart
PAPS 208 A1
240
165
120
120
55