Table of Contents
Advertisement
To attach hose, thread
into metal hole
counter clockwise.
Now the unit can be turned on and programmed.
Programming Instructions:
Coin acceptor:
No programming to acceptor needed if unit was purchased with the standard Imonex Z3 acceptor (8149 JEA part number)
as it is built accept US quarters.
If different acceptor was purchased, see additional literature sent along with unit for programming info.
8
Once unit has been installed use 5871B8 cap plugs (supplied with unit) to seal holes
in canister bottom located in lower cleanout door. Extra cap plugs are included with
the unit in case plug becomes damaged during shipping removal.
hose will
need to start
Edge of
To insert 5871B8 cap plugs into bottom holes, pinch
here.
cap plug into place using index finger and thumb.
With edges of plug resting against edges of hole,
firmly push down on plug with end of hammer or other
blunt object until plug snaps into place.
REV 8-22-19
Advertisement
Table of Contents
