Messages - Sony Hi-MD WALKMAN MZ-DH710 Operating Instructions Manual

Messages

If the following messages flash in the display window, check the chart below.
Message
AVLS NO
VOLUME
OPERATION
BLANKDISC
BUSY WAIT A
MOMENT
CANNOT PLAY
CANNOT
RECORD OR
PLAY
DATA SAVE
D-L READY
EJECT DISC OK • The player has finished communicating with the computer and it is safe
END
ERROR
ERROR XX
FORMAT
ERROR DISC
GROUP FULL
HOLD
44
Meaning/Remedy
• AVLS is set to "AVLS On" and so the volume cannot rise higher.
, Set AVLS to "AVLS Off" (page 27).
• A disc with no recording on it is inserted.
• The player is accessing disc information.
• You tried to operate the player while it was accessing the recorded data.
, Wait until the message goes out (in rare cases, it may take a few
minutes).
• You tried to play a track that is subject to play restrictions.
• You tried to play an MP3 track with a format not supported by this player.
, This player only supports MP3 tracks (MPEG-1 Audio Layer-3/
sampling frequency 44.1 kHz) that have been transferred using the
SonicStage software.
• There is no audio data that can be played on the player.
• The audio data or disc management file has been damaged.
, Replace the disc or format the disc using the SonicStage software.
• The player is writing information to the system file, such as the recorded
data or editing information.
, Wait until the message disappears from the display.
• MD Simple Burner is now ready to record an audio CD to the disc in the
player using Simple mode (see "Software Operation").
to eject the disc from the player or disconnect the dedicated USB cable.
• The player reached to the end of the disc while playing or pressing >.
• There is an internal malfunction in the system.
, Restart the operation by doing steps 1 to 3 on page 43.
• There is an internal malfunction in the system.
, Restart the operation by doing steps 1 to 3 on page 43. If the message
appears again, please consult your nearest Sony dealer.
• A disc with a format that the player does not support was inserted.
, Insert a disc used in Hi-MD mode.
• A disc formatted on the computer was inserted.
, When formatting a disc on the computer, make sure to use the
SonicStage software.
• You tried to create a 256th group on a disc used in Hi-MD mode or 100th
group on a disc used in MD mode.
, You can create only up to 255 groups (on a disc used in Hi-MD
mode) or 99 groups (on a disc used in MD mode) on a disc. Keep the
group number within 255 or 99.
• The player is locked.
, Slide HOLD against the arrow to unlock the player (page 13).