Table of Contents
Advertisement
Crisper Operation
CONCERN
Excess moisture build up in
crisper
It is normal for there to
be some moisture and
humidity in the crisper bin.
Crisper bin can not be
removed
Freezing items in the crisper
Refrigerator operation
CONCERN
Appliance will not run
It is normal for the freezer
fan not to operate during
the automatic defrost cycle,
or for a short time after the
appliance is switched on.
Compressor motor seems
to run too long
At normal room
temperatures, expect your
motor to run about 40%
to 80% of the time. Under
warmer conditions, expect
it to run more often.
The exterior of the
appliance is warm or hot
to touch
This is normal because the
appliance transfers heat
from the inside out through
the outer panels and the
divider between the doors.
User interface will not
respond
To ensure settings are not
accidentally changed the
user interface will go into
sleep mode when not in
use. Press any button to
wake user interface
WHAT TO DO
• Ensure that the crisper is not over packed.
• Adjust crisper humidity slides.
• If crisper bin interferes with the door bins, remove door bins
before removing crisper.
• Position cabinet so that the door can be fully opened.
• Adjust temperature to a warmer setting.
WHAT TO DO
• Ensure that the cord is plugged into a live power outlet and
outlet is switched on.
• Ensure that the household circuit breaker has not tripped or that
the fuse has not blown.
• The appliance maybe in defrost mode, check again in half an
hour.
• Ensure that the doors are not held open.
• Check that large amounts of warm food have not just been
placed inside the appliance.
• Note that the appliance will run more than normal just after you
install it or when adjusting the temperature setting changes.
• Ensure the appliance has the external clearances
recommended in the section "Installing your new appliance".
• The exterior of the cabinet will be much warmer on warmer
days it may even feel hot to touch, as the appliance is working
harder.
• Check that the user interface is in awake mode, refer to section
"About the user interface".
• Check that the user interface is not locked, refer to section
"About the user interface".
• If the user interface is frozen turn the appliance off for five
minutes for the memory to clear, then turn back on.
• Check that the user interface is not in Sabbath Mode, refer to
control instructions. (I&W models only).
EN
21
Advertisement
Table of Contents
