AEG BP330302KM User Manual page 23

P2
Press or turn the knob for the
temperature to start the procedure.
You can use the End function to delay
the start of the cleaning procedure.
During the Pyrolysis the oven lamp is off.
5. When the oven is at its set
temperature, the door locks. The
display shows the symbol
bars of the heat indicator until the
door unlocks.
To stop Pyrolysis before it is
completed, turn the knob for the
oven functions to the off position.
6. When Pyrolysis is completed, the
display shows the time of day. The
oven door stays locked.
7. When the appliance is cool again, an
acoustic signal sounds and the door
unlocks.
10.5 Cleaning reminder
To remind you that the Pyrolysis is
necessary, PYR flashes in the display for
10 seconds after each activation and
deactivation of the appliance.
The cleaning reminder
goes out:
• after the end of the
Pyrolysis function.
• if you press
the same time while PYR
flashes in the display.
10.6 Cleaning the oven door
The oven door has four glass panels. You
can remove the oven door and the
internal glass panels to clean them.
The oven door can close if
you try to remove the glass
panels before you remove
the oven door.
If you cannot
easily remove
the dirt. Time
of the proce-
1. Fully open the door and identify the
dure: 1 h 30
min.
2. Push the tightening component until
and the
3. Hold the pushed component with
and at
4. Identify the hinge to the left side of
CAUTION!
Do not use the appliance
without the glass panels.
hinge to the right side of the door.
it pulls back.
one hand. Use a screwdriver with the
other hand to lift and turn the right
side hinge lever.
the door.
ENGLISH 23