Table of Contents
Advertisement
A M E R I C A N A U D I O
w w w . a d j . c o m
I N S T A L L A T I O N
1. Place receiver on a flat non-metal surface.
2. Connect both UHF antennas to the back of the receiver.
3. Position both UHF antennas vertically and ensure they are fully extended.
4. Turn both Channel A and B Volume Control Dials counter-clockwise to (-).
5. Connect 3pin XLR audio cable to Balanced Channel A/B outputs.
6. Connect ¼ " audio cable to Audio Mix Out.
7. Connect power supply to receiver and power ON receiver and microphones.
8. Check battery levels of both microphones and replace batteries if needed.
TO INSTALL RECEIVER IN A 19-INCH RACK, FOLLOW STEPS BELOW
1. Connect (2) BNC antenna extension cables to back of receiver.
2. Install (2) Rack Ears to both sides of receiver with screw kit. (see image below)
3. Route antenna BNC extension cables from back of receiver to Rack Ears.
4. Secure antenna BNC extension cables to Rack Ears.
5. Connect 3pin XLR audio cable to Balanced Channel A and B outputs.
6. Connect ¼ " audio cable to Audio Mix Out.
7. Connect included power supply to back of receiver.
8. Install and secure with rack screws (not included). (see image below)
9. Connect both included UHF antennas to the Rack Ears on each side.
10. Power ON receiver and microphones.
11. Check battery levels of both microphones and replace batteries if needed.
12
Advertisement
Table of Contents
