Sony LF-B20 Settings Manual page 9

Notes
• Depending on the condition of the Base Station
and the PSP system, it may take a few minutes
®
to complete the settings.
• If more than 5 minutes pass from when the
SETUP MODE LED started to blink, the LED
will go from blinking to fully lit and the Base
Station will no longer register the PSP
system.
In this case, press the SETUP MODE button on
the Base Station again and hold the button
down until the SETUP MODE LED starts to
blink.
• If a message stating "You must update the base
station" is displayed, you must perform a
software version update. You can perform the
update from the Base Station Settings menu
(1 page 25).
5
Check the settings list.
Press the button to finish the settings. A
network settings list is displayed.
Note
If a message stating "The wireless channel of the
base station is set to the 5 GHz range" is
displayed, you must change the settings for the
Base Station.
For details, refer to the Operating Instructions
document supplied with the Base Station.
6
Connect to the Base Station.
Select [LocationFree AP], and then press the
button.
®
A connection to the Base Station is
established.
7
The TV or video picture is displayed.
When a connection to the Base Station is
established, the TV picture (LF-PK1/LF-
X11) or the video picture (LF-B20/LF-B10)
is displayed.
For detailed usage instructions, refer to
"Watching TV or Video on the LocationFree
Player" (1 page 12).
You can close the LocationFree Player by
pressing the
Go to page 19 and set the TV channels (LF-PK1/
LF-X11 only).
To watch TV or video away from home, proceed
to "Preparations and Settings to Watch TV or
Video Away from Home" (1 page 10).
9
button.