Samsung WD14T Series User Manual page 67

Code
AddWash door is open
(applicable models
only)
OC
LC, LC1
3C
3CP
UC
HC
1C
AC
This message appears when you open the AddWash door without tapping and
holding . If this happens, do one of the following:
• Press the AddWash door to close properly. Then, tap and hold
again.
• To add laundry, open the AddWash door and input laundry. Close the
AddWash door properly. Then, tap and hold
Water has overflowed.
• Restart after spinning.
• If the information code remains on the display, contact a local Samsung
service centre.
Check the drain hose.
• Make sure the end of the drain hose is not placed on the floor.
• Make sure the drain hose is not clogged.
• If the information code remains, contact a customer service centre.
Check the drum motor for operation.
• Try restarting the cycle.
• If the information code remains, contact a customer service centre.
The electronic control needs to be checked.
• Try restarting the cycle.
• If the information code remains, contact a customer service centre.
Check the pulsator motor for operation.
• Check if power is supplied properly.
• If the information code remains, contact a customer service centre.
Low voltage detected.
• Check if the power cord is plugged in.
• If the information code remains, contact a customer service centre.
High temperature heating check.
• If the information code remains, contact a customer service centre.
The Water Level sensor is not working properly.
• Turn the machine off, and restart the cycle.
• If the information code remains, contact a customer service centre.
Check communications between main and sub PBAs.
• Turn the machine off, and restart the cycle.
• If the information code remains, contact a customer service centre.
Action
to resume operation.
and try
English 67