Hoover EY 1281DE/1-S Manual page 69

This option allows you to choose between

3 levels of wash intensity modifying the
length of the programme, depending on
how much the fabrics are soiled (can only
be used on some programmes as shown
in the table of programmes).
TEMPERATURE SELECTION
button
This button allows you to change the

temperature of the wash cycles.
It is not possible to raise the temperature

over the maximum allowed for the
programme, in order to protect the fabrics.
If you want carry out a cold wash all the

indicators must be off.
SPIN SELECTION button
By pressing this button, it is possible to

reduce the maximum speed, and if you
wish, the spin cycle can be cancelled.
If the label does not indicate specific

information, it is possible to use the
maximum spin expected in the program.
To prevent damage to the fabrics, it is
not possible to increase the speed
over the maximum allowed for the
programme.
To reactivate the spin cycle press the

button until you reach the spin speed you
would like to set.
It is possible to modify the spin speed

without pausing the machine.
An over dosing of detergent can cause
excessive foaming. If the appliance
detects the presence of excessive foam,
it may exclude the spinning phase or
extend the duration of the program
and increase water consumption.
The machine is fitted with a special
electronic device, which prevents the
spin cycle
unbalanced. This reduces the noise
and vibration in the machine and so
prolongs the life of your machine.
STEAM button
(only available on certain models)
By this option you can add a specific

steam treatment to some washing cycles
(see programme table).
The steam function relaxes the folds and

makes ironing times shorter.
Fibres are regenerated and refreshed,

removing all smells from the items.
A dedicated steam treatment was devised

for each programme,
washing top efficiency depending on item
fabrics and colours.
This option must be selected before
pressing the START/PAUSE button.
NIGHT & DAY button
(only available on certain models)
This option reduces the intermediate spin

speed to 400 rpm, where applicable,
increase the water level during rinsing
and keep the laundry immersed in water
after the final rinse, in order to spread the
fiber perfectly.
During the phase in which the water is

held in the tub, the relevant indicator light
blink to show that the machine is at a
standstill.
Deselect the option to end the cycle with

a spin dry (which may be reduced or
cancelled using the appropriate button)
and emptying phase.
Thanks to electronic control, the water in

the intermediate phases is
silently, making this option very useful for
washing at night.
69
should the load
to guarantee
emptied
be