Hoover EY 1281DE/1-S Manual page 68

To delay the start use the following

procedure:
- Select the required programme.
- Press the delay start button once to
activate it (h00 appears on the display)
and then press it again to set a 1 hour
delay (h01 appears on the display). The
pre-set delay increases by 1 hour each
time the button is pressed, until h24
appears on the display, at which point
pressing the button again will reset the
delay start to zero.
- Confirm by pressing the START/PAUSE
button. The delay countdown will begin
and when it has finished the programme
will start automatically.
It is possible to cancel the delay start by

turning the programme selector to OFF.
If there is a break in the power supply
whilst the machine is operating, when
the power is restored, the machine will
restart from the beginning of the phase it
was in when the power was lost.
The following
selected before
START/PAUSE button.
OPTIONS button
This button allows you to choose between
three different options:
- PREWASHING
This option allows you to make a prewash

and it is particularly useful for heavily
soiled loads (can be used only on some
programmes as shown in the table of
programmes).
We recommend you use only 20% of the

recommended quantities shown on the
detergent pack.
options must
pressing the
- AQUAPLUS
This option (available only in some

programmes) allows you to wash the load
in a much larger quantity of water and
this, together with the new combined
action of the drum rotation cycles, where
water is filled and emptied, will give you
garments which have been cleaned and
rinsed to perfection so that the detergent
dissolves
efficient cleaning action.
This function is for the people with

delicate and sensitive skin.
This function can be used for children's

items and for washing of very dirty items,
for which you are required to use a lot of
detergent, or for washing of Towels
whose fibres have the tendency to hold
the detergent.
- HYGIENE +
Activated when
temperature.
cleaning of your clothes by maintaining the
same temperature for the whole wash.
If an option is selected that is not
compatible
be
programme then the option indicator
light first flashes and then goes off.
RAPID / STAIN LEVEL button
This button allows you to choose between
two different options, depending on the
selected programme.
- RAPID
The button
you select the RAPID (14/30/44 Min.)
programme on the knob and allows you to
select one of three durations indicated.
- STAIN LEVEL button
Once the programme has been selected

the wash time set for that programme will
be automatically shown.
68
completely, ensuring
you set
This option allows
with the
becomes active
an
60°C of
deep
selected
when