Download Print this page
Worx Nitro WG185 Manual

Worx Nitro WG185 Manual

Cordless grass trimmer

Advertisement

Cordless Grass Trimmer
P06
EN
Taille bordure sans fil
P12
F
Cortadora de césped sin cable
P20
ES
WG185 WG185.X

Advertisement

loading
Need help?

Need help?

Do you have a question about the WG185 and is the answer not in the manual?

Questions and answers

Summary of Contents for Worx Nitro WG185

  • Page 1 Cordless Grass Trimmer Taille bordure sans fil Cortadora de césped sin cable WG185 WG185.X...
  • Page 4 100%...
  • Page 6: Table Of Contents

    TABLE OF CONTENTS to reduce the risk of injury. Follow instructions for lubricating and changing accessories. Keep handles dry, clean, and free from oil and grease. 1. SAFETY INSTRUCTIONS 12) Check Damaged Parts - Before further use of the 2. COMPONENT LIST appliance, a guard or other part that is damaged should be carefully checked to determine that 3.
  • Page 7 10. Have servicing performed by a qualified repair l) Do not leave battery pack on prolonged charge when not in use. person using only identical replacement parts. m) After extended periods of storage, it may be This will ensure that the safety of the product is maintained.
  • Page 8: Component List

    TECHNICAL DATA Do not burn WG185 WG185.X ** Batteries may enter water cycle if disposed improperly, which can Voltage 40 V MAX (2x20V MAX) *** be hazardous for ecosystem. Do No-load speed 6000/min not dispose of waste batteries as unsorted municipal waste.
  • Page 9 Installing and Removing the Bump feed See Fig. G Battery Pack Assembling and removing the NOTE: trimmer head • This machine will only run Insert the hex key into the hole when 2 batteries are installed. and rotate the trimmer head It is recommended to use the See Fig.
  • Page 10: Operating Instructions

    FOR BATTERY TOOLS Only one light is The machine is over load. Raise flashing four times The ambient temperature range for the use and the cutting height or push slowly. per cycle. storage of tool and battery is 0℃-45℃. The recommended ambient temperature range for the charging system during charging is 0℃-40℃.
  • Page 11: Troubleshooting

    TROUBLESHOOTING The following table gives problems and actions that you can perform if your machine does not operate correctly. If these do not identify and correct the problem, contact your Worx Customer Service at 1-866-354-Worx. WARNING: Switch the machine off and remove the battery prior to any troubleshooting. Problems Possible Causes Corrective Action...

This manual is also suitable for:

Wg185.x
Save PDF