Table of Contents
Advertisement
ASSEMBUNG EXTENSION WINGS
The extension wings are to be fastened to each end
of the _table.
A straight edge should be usad ta leve!
the extension wings to the table,
To assemble the
extension wings to the saw table, proceed as follows:
1.
If y our saw table has through hales on the s ide
of the table, attach the extension wing ta the table,
as shawn in Fig.16, using the screws,
washers
and
nuls.
2.
If your saw table has
thr~aded
hales on the side
of the table, attach the extension wing ta the table,
as shawn in Fig. 16, using the screws and washers.
The nuts are discarded as they are not needed when
the table is equipped with threaded hales.
NOTE:
The saw must be bolted to the supporting sur-
face or a sturdy ontrigger support must be used if a
table extension over 24 inches long is _attached to the saw.
Fig.
17
ASSEMBLING BLADE GUARD
AND SPLITTER ASSEMBLY
1.
Remove cap screw, washer and outer splitter bracket
helder (A) Fig. 18. Also remove bi ade, blade arbor nut and
flan ge (B),
2.
Hold a straight edge against the saw arbor flange (C)
and splitter bracket (D) Fig. 18, and check for alignment on
the top and bottom of the splitter bracket (0). If an adjust-
ment is necessary loosen two screws that hold splitter bracket
(D) ta the trunnion and shift the bracket (D) ta bring it into
alignment with- saw arbor flange. Then tighten the two screws
that hold splitter bracket. NOTE: Snap out the nut retainer
in the splitter bracket _ .. to
-~make
this· adjustment easier to
perform.
8
Fig.
16
ASSEMBLING GUIDE RAILS
1.
The guide rail with the calibrations goes on the front of
the saw table and should be positioned as shawn in Fig.17.
Assemble the front guide rail (F) Fig.17to the saw tàble using
two spacers (B) and special screws (A) threaded into tapped
hales
(C).
2.
Use the remaining two spacers (B) and special screws (A)
Fig.17, to attach the front guide rqil to the extension wiilgs and
fasten using the flat washers, lockwashers and hex nuts (D)
provided.
3.
Assemble the plain guide rail to the rear of the saw table
and extensioÎl wings in the same manner as the front-guide·rail.
Be sure bath' guide rails extend out ta the same side of the
saw.
Fig.
1 8
Advertisement
Table of Contents
