Table of Contents
Advertisement
8.
WHEN cutting mouldings, NEVER run the stock
· bétween the tence and the moulding cutterhead..
Refer
to mould.ing applications .ir\
lnstr~ction
Manual.for details.
.9..
DIRECTION OF FEED.. Feed work into à blade
or cutter against the direction or' rotation of the blade
or.
cutter
only.
10. NE VER use the tence as a eut-off gage when cross
cutting.
11. NEVER attempt' to free a stalled saw blàde without
first turning the saw OFF.
·
12. PROVIDE adequate support to the rear and sidas
of the saw table· for wide or long workpieces.
13. AVOlD KICKBACKS (work thrown back tow.ard yeu)
by keeping blade shf!rp, keeping rip fence p;Jrallel_ to
the saw blade, keepirig splitter and antikickback fingers
and guard in place and operating, by not releasing .work
bef ore i't is pushed a Il the way past the saw blade,
and by not ripping work that is twisted or warped or
does not have a straight edge to guide along the tence.
14. AVOlD. awkward . operations
and
hand positions
where a sudden s
1
ip cou Id cause y our ha nd to move
into
the cutting tool.
UNPACKING
Carefully unpack the saw and ali loose items from
the carton.
Fig. 2, i llustrates ali . the
1
oose items
packed with your
saw.
1
t>' ,:·;;~
?Rfiii"O
,.,~t"
1
Guide Rails
Fig. 2
2
Extension Wings
3
See-Thru Blade Guard and Splitter
4
Miter Gage
5
Belt and Pulley Guard
7
Rip Fence
8
V-Belt
9
Motor Pulley
10 Hardware for Extension Wings
15
11
Blade Guard and Splitter Mounting Hardware
12 Tilting and Raising Lock Knobs, Switch Bracket,
Motor Mounting Hardware, Guide Rail Hardware
13 Motor Mounting Plate
14 Motor Mounting Plate Bracket
15 Arbor Wrench
16
Raising and Tilting Handwheels
3
Advertisement
Table of Contents
