Table of Contents
Advertisement
3.
Thread nul (A) Fig. 19, onto threaded end of rod
(B) and thread rod (B) into the hale 'provided in the
trunnion bracket (C) as shown.
If necessary a rod or
pin can be placed into hole (D) to assis! in providing
leverage when threading the rod (B) into the trunnion
bracket.
Then tighten nul (A) against trunnion bracket
(C), as Shawn.
4.
Assemble bracket (A) Fig. 20, to bracket (B) using
the screw, nul and lockwasher (C). Assemble the screw,
nul and Jockwasher (D) to bracket (A) as shown.
s.
Place bracket (B) Fig. 20
on rod (E) as shown,
and fasten using the screw and nul (F).
6.
Assemble the center portion of the splitter to ihe
splitter bracket (D) Fig. 18, and replace splitter bracket
holder (A) Fig. 18.
7.
Remove nul, screw and lockwasher (B) Fig. 21,
from the rear splitter bracket and assemble the splitter
(A) to the bracket using the screw, nul and lockwasher
(B).
s.
Replace saw blade and using a straight edge make
sure the splitter (A) Fig. 21, is in alignment with the
saw blade, as shown.
If necessary, the rear mounting
bracket assembly (C) can be adjusted to bring the
splitter into alignment with the saw blade.
,
Fig.
21
9
Advertisement
Table of Contents
