Table of Contents
Advertisement
ASSEMBLING SWITCH TO SAW CABINET
IMPORTANT:
When assembling the switch to the saw
cabinet
1
make sure the ·motor power cord is NOT
conM
nected to the power·Murce.
L
Remove outer hex nut from switch stem.
Leave
shakeproof
lockwasher
(A) Fig. 12, and inside hex
nut on switch.
NOTE:
The proper grounding of the
switch to prevent shock hazard, depends on the use
of the shakeproof lockwasher in the manner shown.
2.
lnsert switch stem through hole in front of saw
cabinet making sure the keyway in the switch stem
is in the down position.
3.
Place switch bracket (B) Fig. 13, on switch stem
with key in switch bracket engaged with keyway in
switch stem and fasten in place with hex nul (C) thal
was removed in STEP 1.
4.
IMPORTANT:
Alter attachlng switch to cabinet
use the two tle straps provided and tle the power cord
and motor cord to front hole located on the ledge of
the saw cabinet and the motor cord to the back hole,
as shown ln Fig. 13A.
Leave ali excess motor cord
hang out of the back of cabinet.
5.
IMPORTANT:
We suggest thal when the saw
i.s not in use, the switch be locked in the "OFF"
position using a padlock, as·shown in Fig. 14. Catalog
Padlock is available as
an accessory.
Fig.
13
Fig.
13A
fig.
ASSEMBLING RAtSING AND TILTING
HAN~WHEELS
AND LOCK KNOBS
7
Assemble the raising and tilting handwheels (A) and
lock knobs (B) to the raising and tilting screws, as
shawn in Fig. 15. Make sure the slot in the handwheels
enga9e
with the roll pins. in the raising and tilting
screws.
Advertisement
Table of Contents
