Cleaning Or Replacing Gun Liner - Hobart Welders H-10 Owner's Manual

7-6. Cleaning Or Replacing Gun Liner

8 mm
OM-228 187 Page 24
Y Disconnect gun from unit.
Head Tube
Remove nozzle, contact tip,
adapter, gas diffuser, and wire
outlet guide.
Lay gun cable out straight
before installing new liner.
10 mm
Blow out gun casing.
Tools Needed:
8 mm / 10mm
Remove liner.
To Reassemble Gun:
Insert new liner.
Install wire outlet guide so that 1/8
in (3 mm) of liner sticks out. Hand
tighten outlet guide, and then
tighten two full turns more.
Cut liner off so that 3/4 in (19 mm)
sticks out of head tube.
Install gas diffuser, adapter, contact
tip, and nozzle.
Ref. 802 446-A