Advertisement
ASSEMBLING
THE DECK ADAPTER
(#62468)
TOTHE
MOWER
DECK
Contents
of Hardware Pack for Deck Adapter:
See Figure 23.
Key
Qty.
Description
A
B
C
D
E
F
G
H
I
J
K
2
4
2
3
4
3
12
5
1
1
1
Hex Bolt, 5/16" x 1"
Hex Bolt, 1/4" x 3/4"
Carriage Bolt, 5/16" x 3/4"
Nylock Nut, 5/16"
Nylock Nut, 1/4"
Flat Steel Washer, 1/4" Std.
Flat Washer, 5/16" Std.
Nylon Washer
Mounting Strap
Angle Bracket
Mounting Bracket
C
NOT SHOWN FULL SIZE
FIGURE 23- FULL SIZE
NOTE: Not all of the hardware will be used for any one
particular fit up.
CAUTION:
Mower deflector must be
replaced when Mow-N-Vac deck adapter
is removed. Do Not operate mower
unless adapter or deflector is in place and
properly mounted.
FiTTiNG TO SEARS TRACTORS
(and other tractors listed on white fold out sheets)
If you have a Murray brand tractor with a 38", 40" or 46"
deck, go directly to instructions on page 16.
ATTENTION:
The yellow fold out sheet contains the
templates for Sears tractors.
,
Identify your mower deck (see fold outs) and cut
out the correct discharge opening template for your
mower deck size. If there is no template for your deck
size you can make your own template by marking
around a piece of cardboard held against the edge of
the discharge opening.
,
Tape the template to the face of the adapter, locating
template approximately
1/2" from front and 1/4" down
from top of adapter. Keep as close to top as possible.
See figure 24. Mark outline of template on face of
adapter using white crayon, nail or scriber. Drill a
starting hole inside the outline, then use a saber saw
or key hole saw to cut out the opening.
See figure 24.
1/4" DOWN
IMPORTANT:
Keep
cut-off
as close
to
the top edge as possible,
1/2" FROM FRONT
FIGURE 24
1. Remove the mower discharge deflector from your
mower deck. Save the deflector and hardware for
remounting.
14
Advertisement
