Craftsman 79960 Owner's Manual page 9

ASSEMBLY
ASSEMBLY CONFIGURATIONS
Your machine has been partially assembled at the
factory. The remaining assembly steps should be done
on a clean, level surface, Choose the mode of operation
from the pictures below and then go to the page for
assembly of the chipper/vac in the desired configuration..
CAUTION
To preventpersonalinjury or propertydamage, do not
connect the spark plug or start the engine until all
assembly steps are complete and you have read and
understood the safety and operating instructions in
this Manual
Walk-behind vacuuming - see Page t0
WALK-BEHIND VACUUMING
OPERATION CHECKLIST
v" Collection bag installed and zipped
v' Baffle plate off (provided with
optiona] vacuum hose kit only)
V' Vacuum inlet cap installed
v' Handlebars positioned toward the
rear of the machine
Blower operation, see Page 12
BLOWER OPERATION CHECKLIST
v' Handlebars positioned toward the
front of the machine.
v" Collection bag removed
v" Blower deflector installed.
v' Vacuum inlet cap installed..
v' Baffle plate off (provided with
optional vacuum hose kit only)
Using the chipper, see Page 10
CHIPPER OPERATION CHECKLIST
v' Handlebars positioned toward the rear of
the machine,
v" Collection bag installed and zipped
v" B{ower deflector and baffle plate (optional)
off
i/" Vacuum inlet cap installed.
Using the vacuum hose (optional) - see Page 14
VACUUM HOSE OPERATION CHECKLIST
v' Handlebars positioned toward the rear of the
machine
Collection bag installed and zipped
v" Baffle plate on
v' Vacuum hose installed