Craftsman 79960 Owner's Manual page 14

ASSEMBLY
ASSEMBLY FOR OPTIONAL VACUUM
HOSE OPERATION
NOTE: The optional Vacuum Hose is designed for
stationary vacuuming operation only,
STEP 1: MOVE HANDLEBARS TO VACUUMING
POSITION
1. Stop the engine, disconnect the spark plug wire
from the spark plug, and make sure that all moving
parts have come to a complete stop,
2. Squeeze the handlebar end (A in Figure 11 inset with
decal "Push in Here") toward the center of the machine
to release end from the notch in the mounting bracket
and swing the handlebars up over the machine toward
the rear
3. Position the handlebar ends in the "vacuum" notches
of the brackets (B in Figure 11 inset) r
STEP 2: REMOVE BLOWER DEFLECTOR (IF
INSTALLED)
Turn retaining knob (D in Figure 12) until the tab on the
knob is out of the slot in the blower deflector,, Pull the
sides of the blower deflector (A in Figure 12) out of the
slots in the discharge opening (B) and slide the blower
deflector off the machine.
Handlebars in Vacuum
Position
Figure 11: Handlebar position for vacuuming.
A
Figure 12: Remove blower deflector_
14