Table of Contents
Advertisement
In the case of right bevel cut
(a) (b)
1. Inside corner 2. Outside corner
Table (A)
–
Molding
Bevel angle
position
52/38°
in the
type
figure
For
(a)
Right
inside
33.9°
corner
(b)
For
(c)
outside
(d)
corner
Table (B)
–
Molding
position in
the figure
For inside
(a)
corner
(b)
For outside
(c)
corner
(d)
Example:
In the case of cutting 52/38° type crown molding for
position (a) in the above figure:
•
Tilt and secure bevel angle setting to 33.9° RIGHT.
•
Adjust and secure miter angle setting to 31.6°
RIGHT.
•
Lay crown molding with its broad back (hidden)
surface down on the turn base with its WALL
CONTACT EDGE against the guide fence on the
saw.
•
The finished piece to be used will always be on
the RIGHT side of the circular saw blade after the
cut has been made.
(c) (d)
1
2
Miter angle
45° type
52/38°
type
Right
Right
30°
31.6°
Left
31.6°
Right
31.6°
Molding
Finished
edge against
piece
guide fence
Wall contact
Finished
edge should
piece will be
be against
on the Right
guide fence.
side of blade.
Ceiling
contact edge
Finished
should be
piece will be
against guide
on the Left
fence.
side of blade.
Wall contact
edge should
be against
guide fence.
Cutting aluminum extrusion
3
45° type
► 1. Vise 2. Spacer block 3. Guide fence 4. Aluminum
extrusion 5. Spacer block
Right
When securing aluminum extrusions, use spacer blocks
35.3°
or pieces of scrap as shown in the figure to prevent
Left
deformation of the aluminum. Use a cutting lubricant
35.3°
when cutting the aluminum extrusion to prevent build-up
of the aluminum material on the circular saw blade.
Right
35.3°
WARNING:
round aluminum extrusions. Thick or round alumi-
num extrusions can be difficult to secure and the work
may loosen during the cutting operation which may
result in loss of control and serious personal injury.
Wood facing
WARNING:
facing to the guide fence. The screws should be
installed so that the screw heads are below the
surface of the wood facing so that they will not
interfere with the positioning of the material being
cut. Misalignment of the material being cut can case
unexpected movement during the cutting operation
which may result in a loss of control and serious
personal injury.
CAUTION:
thickness as the wood facing.
27 ENGLISH
1
2
4
5
Never attempt to cut thick or
Use screws to attach the wood
Use the straight wood of even
Advertisement
Table of Contents
