Specifications - Makita LS001G Instruction Manual

SPECIFICATIONS

Model:
Blade diameter
Hole (arbor) diameter (country specific)
Max. kerf thickness of the saw blade
Max. miter angle
Max. bevel angle
No load speed
Laser type
Dimensions (L x W x H)
Rated voltage
Net weight
• Due to our continuing program of research and development, the specifications herein are subject to change
without notice.
• Specifications may differ from country to country.
• The weight may differ depending on the attachment(s), including the battery cartridge. The lightest and heavi-
est combination, according to EPTA-Procedure 01/2014, are shown in the table.
Applicable battery cartridge and charger
Battery cartridge
Charger
• Some of the battery cartridges and chargers listed above may not be available depending on your region of
residence.
WARNING:
Only use the battery cartridges and chargers listed above. Use of any other battery cartridges
and chargers may cause injury and/or fire.
Cutting capacities (H x W) with blade 165 mm in diameter
45° (left and right)
1. Max. Cutting capacity when using a wood facing 20 mm thickness
2. Max. Cutting capacity when using a wood facing 15 mm thickness
3. Max. Cutting capacity when using a wood facing 10 mm thickness
Symbols
The followings show the symbols used for the equip-
ment. Be sure that you understand their meaning before
use.
Read instruction manual.
To avoid injury from flying debris, keep
holding the saw head down, after making
cuts, until the blade has come to a com-
plete stop.
Miter angle
0°
57° (right)
Red Laser 650 nm, Maximum output
495 mm x 400 mm x 470 mm
D.C. 36 V - 40 V max
45° (left)
30 mm x 182 mm
36 mm x 150 mm
(NOTE 1)
30 mm x 127 mm
36 mm x 100 mm
(NOTE 2)
–
–
When performing slide cut, first pull car-
riage fully and press down handle, then
push carriage toward the guide fence.
Do not place hand or fingers close to the
blade.
Never look into the laser beam. Direct laser
beam may injure your eyes.
2 ENGLISH
LS001G
165 mm
20 mm
1.9 mm
Left 47°, Right 57°
Left 46°, Right 46°
-1
4,400 min
1.6mW ( Laser Class 2M )
10.6 - 10.9 kg
BL4025 / BL4040
DC40RA
Bevel angle
0° 45° (right)
46 mm x 182 mm 15 mm x 182 mm
55 mm x 150 mm 20 mm x 150 mm
(NOTE 1) (NOTE 1)
46 mm x 127 mm 15 mm x 127 mm
55 mm x 100 mm 20 mm x 100 mm
(NOTE 2) (NOTE 2)
46 mm x 98 mm
55 mm x 80mm
(NOTE 3)
–
–