1) Carefully turn the STOVE (A) upside down and lay it on a clean soft surface.
2) Insert the TAB of one LEG (B) into the SLOT in the corner of the stove frame.
3) Thread two SCREWS (C) through the holes in the leg and into the stove frame.
Partially tighten the screws with a Phillips screwdriver.
4) Repeat Steps 2 and 3 for the other three legs.
5) Check the alignment and tighten all 8 screws securely with the screwdriver.
DO NOT over-tighten the screws.
ALWAYS attach the feet before using! NEVER plug in or operate this unit if the feet
are not securely attached!
OPERATION
Control Panel: Located at the lower right corner of the insert. Open the door to access it.
5
Need help?
Do you have a question about the YH-2001 and is the answer not in the manual?
Questions and answers