Fueling Instructions - Husqvarna 4213 2007 Owner's Manual

Gasoline utility vehicle
Table of Contents

Advertisement

OIL VISCOSITY
Choose the viscosity according to the temperature as shown in the oil viscosity chart (Figure 23).
-20° C -10° C
0° C
10° C
SAE 10W-30/SAE 10W-40
SAE 5W-20
-4° F
14° F
32° F
50° F
Figure 23 Oil Viscosity Chart
NOTE: Using multi-grade oils (5W-20, 10W-30, and 10W-40) will increase oil consumption. Check oil level
more frequently when using them.

FUELING INSTRUCTIONS

See General Warnings on page 10.
ý
DANGER
• Turn the key switch to the OFF position before fueling.
• Never pour gasoline into the fuel tank when the engine is hot or while it is running.
• To avoid electric arc caused by static electricity, the fuel storage/pumping device must be
grounded. If the pump is not grounded, the vehicle must be grounded to the pump before and
during the fueling operation.
• If the vehicle has an all-weather enclosure installed, be sure the fuel tank is properly vented as
shown (Figure 24, Page 34).
• To avoid the possibility of fire, clean up any spilled gasoline before operating the vehicle.
ý
CAUT ION
• To allow for expansion, do not fill higher than one inch (2.54 cm) from the top of the fuel tank.
Avoid spilling fuel.
1. Remove the passenger seat.
2. Remove fuel cap and fill tank with fresh unleaded gasoline only. See preceding DANGER and CAU-
TION.
20° C 30° C
40° C
SAE 40
SAE 30
68° F 86° F
104° F
2007 HUV4213 Gasoline Vehicle Owner's Manual
Get other manuals https://www.bkmanuals.com
Fueling Instructions
Page 33

Advertisement

Table of Contents
loading

This manual is also suitable for:

Huv 4213-g 2007Huv 4213-gxp 2007

Table of Contents