Fueling Instructions - Husqvarna HUV 4421-G / GXP Owner's Manual

Air Filter Removal
1. Raise the cargo bed, and locate the air filter canister.
2. Release both canister tab locks (Figure 35).
3. Pull the canister cap away from the canister.
4. Remove the air filter cartridge (1). See following NOTE.
NOTE: The air filter cartridge is specifically designed for this engine. It only fits into the canister one way.
Use only the Husqvarna part (P/N 603 00 00-10) designed for this engine.
1
Figure 35 Air Filter Cartridge
Air Filter Installation
1. Push the new air filter cartridge onto the nozzle inside the canister.
2. Place the canister cap, marked TOP, on the top center of the canister.
3. Secure the canister cap with both tab locks.

FUELING INSTRUCTIONS

See General Warnings on page 8.
ý
DANGER
• Turn key switch to the OFF position before fueling.
• Never pour fuel into the fuel tank when the engine is hot or while it is running.
• To avoid electric arc caused by static electricity, the fuel storage/pumping device must be
grounded. If the pump is not grounded, the vehicle must be grounded to the pump before and
during the fueling operation.
• To avoid the possibility of fire, clean up any spilled fuel before operating the vehicle.
1. Remove the fuel cap and fill the tank with fuel. Gasoline vehicles have a black fuel cap; diesel vehicles
have a green fuel cap. See preceding DANGER and following NOTE.
2007 HUV 4421 Gasoline and Diesel Vehicle Owner's Manual
Fueling Instructions
Page 43