Connecting The Water Supply Hose - LG F2T2TYM0W Owner's Manual

global_main.book.book Page 13 Tuesday, October 18, 2022 2:42 PM
• Make sure that all four feet are stable and
resting on the floor.
NOTE
• Do not install the appliance on a plinth, stand or
elevated surface unless it is manufactured by LG
Electronics for use with this model.
2
To increase the height of the appliance, turn
the feet clockwise. To decrease the height of
the appliance, turn the feet anticlockwise..
3
Check if all lock nuts at the bottom of the
appliance are secured properly.
NOTE
• Proper placement and levelling of the appliance
will ensure long, regular, and reliable operation.
• The appliance must be 100% horizontal and
stand firmly in position on a hard flat floor.
• It must not 'Seesaw' across corners under the
load.
• Do not let the feet of the appliance get wet.
Failure to do so may cause vibration or noise.
Connecting the Water
Supply Hose
Note for Connection
• Water pressure must be between 50 kPa and
800 kPa (0.5‒8.0 kgf/cm²). If the water pressure
is more than 800 kPa, a decompression device
should be installed.
1
• Periodically check the condition of the water
supply hose and replace the water supply hose if
necessary.
NOTE
• Do not overtighten the water supply hose or use
mechanical devices to tighten onto the inlet
valves.
• No further backflow protection required for
connection to the water inlet.
Checking the Rubber Seal
Two rubber seals
supply hose. They are used to prevent water leaks.
Connection to taps is sufficiently tight.
• Do not use mechanical devices such as multi
grips to tighten the water supply hose. Ensure
that the curved end of the water supply hose is
connected to the appliance.
INSTALLATION
are supplied with the water
a
13