AEG 65Z Instruction Manual page 78

Manual for Model 65Z
Trouble shooting guide
Before calling for service, check the following items. If the problem still persists, contact
the place of purchase or your nearest authorized dealer.
Problem
1. The machine is not threaded
correctly.
2. The thread tension is too tight.
Upper
3. The thread is too thick for the
needle.
thread
breaks
4. The needle is not inserted
correctly.
5. The thread is wound around the
spool holder pin.
6. The needle is damaged.
1. The bobbin case is not inserted
correctly.
Lower
thread
breaks
2. The bobbin case is threaded
wrong.
1. The needle is not inserted
correctly.
2. The needle is damaged.
Skipped
3. The wrong size needle has been
stitches
used.
4. The foot is not attached correctly.
5. The machine is not threaded
correctly.
The needle is damaged.
1.
2. The needle is not correctly
inserted.
Needle
3. Wrong needle size for the fabric.
breaks
4. The wrong foot is attached.
5. The needle clamp screw is loose.
Cause
76
Correction
1. Rethread the machine.
2. Reduce the thread tension (lower
number).
3. Select a larger needle.
4. Remove and reinsert the
needle (flat side towards the
back).
5. Remove the reel and wind up
the thread onto the reel.
6. Replace the needle.
1. Remove and reinsert the
bobbin case and pull on the
thread. The thread should
run easily.
2. Check both bobbin and
bobbin case.
1. Remove and reinsert the
needle (flat side towards the
back).
2. Insert a new needle.
3. Choose a needle to suit the
thread.
4. Check and attach it correctly.
5. Rethread the machine.
1. Insert a new needle.
2. Insert the needle correctly
(flat side towards the back).
3. Choose a needle to suit the
thread and fabric.
4. Select the correct foot.
5. Use the screwdriver to tighten
the screw.
Reference
14
23
19
18
14
18
13
13
18
18
19
21
14
18
18
19
-
18