Step 3: Adding A Vcr (Advanced Connection) - Sony SAT-T60 Installation Manual

If your TV and VCR have A/V jacks
1a
Connect the AUDIO/VIDEO OUTPUT
jacks of your Satellite Receiver to the A/V
input jacks of your VCR using the
supplied A/V cable.
Then, connect the A/V output jacks of
your VCR to the A/V input jacks of your
TV using an A/V cable. (Be sure to match
the colors on the jacks with the colored
plugs on the A/V cable.)
If your TV and VCR have S-Video jacks
1b
Use an S-Video cable (supplied) instead of
the yellow video connection shown in
z
Tip
To allow your Satellite Receiver to control
the recording functions of your Sony VCR,
see "Step 4: Connecting the IR Controller
(Advanced Connection)" on page 22.
1c
If your TV and VCR do not have A/V
jacks
Connect the VHF/UHF (SAT) OUT jack
on the Satellite Receiver to the VHF/UHF
input jack on your VCR using coaxial
cable.
Then, connect the VHF/UHF output jack
on your VCR to the VHF/UHF input jack
on your TV using coaxial cable.
Set the CH 3|4 switch of your VCR to the
channel that does not carry broadcasts in
your area.
Note
With this connection, your input source is
channel 3 or channel 4 depending on how
|
you set the CH 3 4 switch on your VCR.
Step 3: Adding a VCR
You can save recorded programs by adding a VCR.
Satellite Receiver
AC In
ACCESS CARD
.
1a
1a
A/V Cable
(Advanced Connection)
SATELLITE IN CNTRL
TEL LINE
OUT
2 1
SERIAL
OPTIONAL REQUIRED
IR
1a
A/V Cable
S Video Cable
VCR
Coaxial
1b 1c
Cable
S Video Cable
OUTPUT DIGITAL VHF/UHF IN
AUDIO OUT
2 1
(OPTICAL)
POWER OFF
PASS-THRU
ONLY
VHF/UHF (SAT) OUT
CH
3 4
VHF/UHF
POWER OFF
PASS-THRU
S-VIDEO
1b 1c
Coaxial
Cable
TV
21